Simple hardware configuration of ElastiStor

The following figure illustrates a simple hardware setup, to form an HA Group, that you can use to get started:

simple_harware_conf

Connect the SAS cable between the SAS port of the Node and Disk Array’s IN port . To form a daisy chain, connect SAS cable between OUT port of one Disk Array and IN port of another Disk Array. This sets up a group of Nodes.  

An HA Group can have a maximum of four Nodes.

ElastiStor in High Availability mode

The following hardware setup diagram is a typical configuration of CloudByte ElastiStor in High Availability mode. Hardware_setup_diagram_HA